Select Page

TF Variety Flanges
Model TF flanges are made from the identical high-strength cast iron as the S flanges, but are designed to accommodate the worldwide typical Taper Lock bushing for effortless installation and removal
TF Type flanges allow for mounting the bushing on the front (hub) side with the flange
TF flanges can be found in sizes six by means of sixteen and might be made use of with any style of sleeve as pictured on page SF-5
TR Style Flanges
TR flanges are comparable to your TF design, but permit for the Taper Lock Bushing to get mounted and removed from
the reverse or serration side of the flange
The constrained torque ratings from the Taper Lock Bushings enable TR flanges to only be used with EPDM or Neoprene sleeves
Different bushing sizes are made use of, so they’ve different highest bores compared to the TF flanges
Sizes 6 by 16 can be found
Taper-Lock Bushings
The marketplace regular taper lock bushing is a split design making it possible for a compression fit from the flange on the shaft without set screws
The basic layout helps make the set up and elimination simple even though the 8° taper grips tight and supplies great concentricity
A Diminished degree of inventory is often achieved as a result of the numerous other electrical power transmission elements that use Taper Lock Bushings such as: sheaves, sprockets, and pulleys
doesn’t supply the Taper-Lock Bushings themselves as these are extensively available from other manufacturers