Select Page

“H” CLASS Refuse Drag Chains is used for conveying sawdust,wood chips, pulp, garbage, tankage, ashes, and other abrasive spend through either wooden or steel troughs. Because of its large, wide opening area, “H” CLASS Refuse Drag Chain provides Leaf Chain sizeable transporting capacity when operated at moderate speeds.
Leading face of each barrel is flat, providing a wide area to push material along the trough and also to keep the chaim from riding over the top of the material. The rounded internal side of the barrel is usually carefully shaped to create excellent sprocket get in touch with. Sidebars are reinforced with wearing shoes which provide both
additional wearing surface and stiffening for the hyperlink. A vertical member on each sidebar assures added link rigidity and defends the pin from harm.
“H”CLASS Refuse Drag Chain is available in EVRT-POWER Promal or Duramal with a tensile strength range of 36,400 to 52,000 pounds. This rugged working chain is available in a pitch selection of 5.000 to 8.000 inches. Each link is produced in accordance with manufacturer’s requirements and may end up being interchanged with links created by other chain manufacturers. “H”CLASS Refuse Drag Chain comes in riveted construction just. Grease chambers, cored into each link’s barrel, keep grease which lubricates pins.
Wide faced sprockets, either of machined or cast metal, are recommended for”H” class Refuse Drag Chain procedure. Links should be operate in direction of the closed barrel.