Select Page

FHDFS Type Floating Shaft Couplings
The FHDFS Sort coupling consists of two flex-rigid couplings and one particular floating shaft. The coupling is provided together with the rigid hubs outboard except if otherwise specified. The coupling includes exposed bolts only.
Features
Flex Hubs for lengthy lifestyle
Typical 20° strain angle
Heat taken care of bolts for higher strength
Corrosion resistant bolts and nuts for ease of upkeep
Accommodates parallel and angular misalignment
Elimination of center assembly makes it possible for forease of servicing without repositioning machinery
Rigid hubs outboard enables for larger shaft diameters
Made for high-torque low-speed applications that take place in mill operations
Ordering Data
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical etc.
Power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Connecting equipment shaft sizes.
Specify which hubs are to become utilised about the gear (Rigid or Flex).
Rigid hubs are going to be employed on the tools unless of course otherwise specified.
Length of floating shaft could have an impact on max angular misalignment.

FMM Kind Mill Couplings
The FMM Type coupling consists of a single conventional flex hub, 1 universal straight bored hub as regular, two sleeves and 1 accessory kit. This coupling is provided with exposed bolts as typical. Shrouded bolts are available upon request as a result of size 5.five.
Functions
For prolonged life
Regular 20° pressure angle
Heat treated bolts for better power
Corrosion resistant bolts and nuts for ease of servicing
Supplies parallel, angular misalignment and finish float
Flex Half coupling interchangeable with marketplace standards
Long Universal Hub supplied to customer specs with straight or tapered bores
Ordering Facts
Application: Driver and Driven.
Form and size of coupling, horizontal, vertical etc.
Power: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is required.
Specify counterbore dimensions if preferred.
Submit a drawing if out there.