Select Page

Energy UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is made solely for the compact lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit continues to be broadly employed inside the market of logistic units for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled from the solenoid valve together with the pace controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is created solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve plus the velocity controlled through the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is reduce, the decreasing motion is controlled through the manual override function.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This energy unit is built exclusively for that substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve plus the speed managed by a strain compensated flow management valve.
Power UNITS FOR LIFT TABLE 4
Common Description
This power unit is intended exclusively to the massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve plus the pace managed by the adjustable needle valve. Once the lift rises to a large positoin, but the energy supply is lower, the decreasing motion is managed by the manual override function.
Particular Notes
one. This electrical power unit is of S3 duty cycle, which can only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned just before installation of the power unit.
three. Viscosity of the oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities.N46 hydraulic oil is suggested.
4. Oil shifting is required right after the first one hundred operation hours,afterwards when just about every 3000 hrs.
five. The electrical power unit proven is created to be mounted vertically.