Select Page

C Style Flex-Flex Couplings
The C Style coupling consists of two flex hubs, 1 sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Variety coupling include one particular flex hub, 1 rigid hub, one sleeve, one accessory kit consisting of seals and snap rings.
Characteristics
Simple and affordable sort of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Available as vertical and horizontal couplings
Wide assortment of exclusive variations including full-flex, flex-rigid mill motor
Common configurations can be found from the shelf
Ordering Facts
Application: Driver and Driven.
Kind and dimension of coupling, horizontal, vertical etc.
Energy: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Variety Couplings
Ordering Info
Puller Holes are common on sizes 4 by way of twelve.
Puller Holes can be found for sizes 7/8 by 3.5 at an extra charge.
The BSE (distance Amongst Shaft Ends) may well vary between G and G1.
Interference bores without set screws are typical unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Part.
Larger sizes can be found, please seek advice from Technical Support.