1. The pitch&tooth type of double sided timing belt is same as synchronousbelt.
2. There are two kinds of double sidedtiming belt:
DAtype: Arrangement symmetrical ( see sectiona)
DB type: Arrangement overlapping ( see section b)
Note: we can produce symmetrical (DA) & overlapping (DB) two kinds doublesided timing belt,
forparticular specification, we can also make according to clients' drawing orsample.
D-MXL | 1.53 | 0.06 |
D-XL | 3.05 | 0.12 |
D-L | 4.58 | 0.18 |
D-H | 5.95 | 0.234 |
D-XH | 15.49 | 0.61 |
D-XXH | 22.11 | 0.87 |
D-T2.5 | 2 | 0.08 |
D-T5 | 3.40 | 0.134 |
D-T10 | 7.0 | 0.275 |
D-T20 | 13.0 | 0.512 |
HTD.DA-8M | 8.17 |
Noticeof keeping and installing.
1.Don't crimp when carrying, otherwise the tension element will buckle allowed minbend
diameter.(See table1)
2.Don't put belt long in abnormal state. ( See table1)
3.Please put the belt in dry place and avoid the scorching of thesun.
4.Please shorten central distance and loosen tension pulley when installing. Don'tforce the beltin.
5.Teeth with wheel should be 90?angle to belt runningdirection.
6. The parallel rate of driving gear and passive gear should be about tangent =1/1000.
Inaccurateness will influence its life ofuse.
7. Ifbelt of driving gear deviates, please adjust it and wheel'spressure.
8. With it drives, central distance changes and belt loosen. Please checkwhether belt loosen or not and
adjustthe axle.
9. Timing belt should be installed as different type and width ofbelt.
10.Tensionpulley should be installed on side of transmission belt.
T type synchronous belt | MXL,T2.5 | 15 | |
XL,T5 | 15 | ||
AT5,L,T10 | 20 | ||
AT10,H | 40 | ||
XH,T20 | 70 | ||
XXH,20M | 100 | ||
Arc tooth synchronous beltf | 15 | ||
25 | |||
40 | |||
V belts Timing belts belts catalog
home
home | chains | sprockets | coulpings | pulleys | belts | gearbox and reducer | shaft collar | gear&rack | motor | motor base | universal joints |
Copyright (c) 2007
TEL:+86-130-8398-8828